Camaro Subframe Connectors – Bolt On Conversion – HHRS


  • Camaro Subframe Connectors – Bolt On Conversion – HHRS
  • SubFrame Connector plates let you bolt your stock or aftermarket subframe to your 3″ wide subframe connectors instead of welding!
  • Plates are oversized for trimming and bending as desired to fit your stock or aftermarket subframe.
  • Allows for subframe removal if needed
  • When installed, connector plates allows the subframe to be self aligning and puts it right back where it was before removal.
  • Plates are laser cut from 3/16″ HRPO
  • 7/8″ OD x 1/2″ ID x 3 3/4″ Long DOM Crush Tubes
  • Designed for 2″x 3″ Rectangular Tube  Subframe Connectors
  • Crush tubes are pre-cut at a length of 3 3/4″ long for an approximate 3/8″ run by off each side of tube for Mig & Tig welding applications or can be trimmed for flush mount Tig application if desired.
  • Plates are oversized for trimming, bending & welding to your stock subframe or others
  •  Comes with an 18ga. drill pattern to fit 2″x 3″ tube for easy layout
  • Kit comes with (4) Plates, (6) Crush Tubes. (6) 1/2 – 20 Grade 8 Yellow Zinc Hex Bolts, Nylock Nuts & Flat Washers
  • See additional details below

6 in stock (can be backordered)

  • Camaro Subframe Connectors – Bolt On Conversion – HHRS
  • Fabrication & Welding skills required for installation
  • Trim to fit as necessary
  • Due to the manufacturing process, some bolts may be a snug fit thru the crush sleeves, using antiseize lubricant is recommended.
  • Standard delivery time is 1-2 weeks for in stock items
  • Subject to back order depending on material availability
  • Made in Mooresville, NC
Additional information
Weight 15 lbs
Dimensions 16 × 16 × 3 in


There are no reviews yet.

Be the first to review “Camaro Subframe Connectors – Bolt On Conversion – HHRS”

Your email address will not be published. Required fields are marked *