Camaro Subframe Connectors – Bolt On Conversion – HHRS
$240.95
- Camaro Subframe Connectors – Bolt On Conversion – HHRS
- SubFrame Connector plates let you bolt your stock or aftermarket subframe to your 3″ wide subframe connectors instead of welding!
- Plates are oversized for trimming and bending as desired to fit your stock or aftermarket subframe.
- Allows for subframe removal if needed
- When installed, connector plates allows the subframe to be self aligning and puts it right back where it was before removal.
- Plates are laser cut from 3/16″ HRPO
- 7/8″ OD x 1/2″ ID x 3 3/4″ Long DOM Crush Tubes
- Designed for 2″x 3″ Rectangular Tube Subframe Connectors
- Crush tubes are pre-cut at a length of 3 3/4″ long for an approximate 3/8″ run by off each side of tube for Mig & Tig welding applications or can be trimmed for flush mount Tig application if desired.
- Plates are oversized for trimming, bending & welding to your stock subframe or others
- Comes with an 18ga. drill pattern to fit 2″x 3″ tube for easy layout
- Kit comes with (4) Plates, (6) Crush Tubes. (6) 1/2 – 20 Grade 8 Yellow Zinc Hex Bolts, Nylock Nuts & Flat Washers
- See additional details below
5 in stock (can be backordered)
Reviews
There are no reviews yet.